Here’s how we made our Bridesmaids’ gifts

We made both our groomsmen gifts and our bridesmaids gift ourselves. Here’s quick recap of how we made the bridesmaid gifts:

It all started with this “log” we pulled out of our firewood pile:
2016-07-30-15-12-43

Robin milled it into 2″ slabs:

Marking out the holes for drilling:
2016-08-21-08-29-57

Holes drilled:
2016-08-21-11-32-55

2016-08-21-11-25-28

Masked off the nice live edge:
2016-08-21-12-04-31

Some hand chiseling for some special pockets:
2016-08-21-12-37-23

Spray painted the surface. This is both to seal the wood a bit for air escaping into the epoxy, as well as for the metallic sheen on the insides of the holes. It’ll be discreet, but in a few of the pockets should add a very nice glow.
2016-08-22-11-34-37

Placing objects in, with a little bit of epoxy to seal coat and hold things in place:
2016-08-28-17-22-48

Too much epoxy. It was annoying to clean up. We also mixed in a little bit of “rose transparent” glitter to add some more shiny:
2016-08-28-18-44-30

Here’s a close up of one of them after the first epoxy fill:
2016-08-28-18-44-47

Now it’s time to dish them out and reveal that wood again!
2016-08-29-17-39-09

2016-08-29-17-39-20

2016-08-29-19-09-47

Some minor defects that need patching/filling:
2016-08-29-19-09-50

Done dishing/sanding, now we reveal the live edge and put a thinned coat of polyester resin over the whole thing, to seal the grain and add some waterproofing:
2016-09-04-12-48-29

And then after this we put on a thick coat of pure polyester resin. We should have hung them to dry instead of letting them dry sitting face up, the end result was a tiny flat spot in the center of each ring dish. Oh well, they still came out excellent considering this is our first time doing a ring dish, inlay with polyester resin, milling firewood lumber, basically all of it!

Here’s the final shots after drying and putting rubber feet on:

_dsc9180

_dsc9187

_dsc9186

_dsc9185

_dsc9183

_dsc9184

_dsc9189